Opticut 5.25 May 2026

| Operation Type | Concentration (%) | Refractometer Reading | Application Example | | :--- | :--- | :--- | :--- | | | 3% - 4% | 1.5 - 2.0 | Surface grinding, Blanchard grinding | | General Turning/Milling | 5% - 6% | 2.5 - 3.0 | Drilling, milling aluminum, sawing | | Heavy Machining | 7% - 8% | 3.5 - 4.0 | Deep hole drilling, tapping, broaching | | High-Alloy Steel | 9% - 10% | 4.5 - 5.0 | Inconel, Titanium (moderate ops) |

By maintaining a consistent 5% to 6% concentration, you can expect longer tool life, better surface finishes, and a cleaner workplace. Whether you are running a 5-axis CNC mill or a simple manual lathe, if visibility and corrosion protection are your top priorities, Opticut 5.25 is a proven, reliable solution. Disclaimer: The term "Opticut 5.25" may refer to specific commercial products. Always consult the manufacturer’s Safety Data Sheet (SDS) and technical data sheet for batch-specific instructions. Opticut 5.25

Rust on machine table or parts. Solution: Check concentration with a refractometer. If below 4%, add concentrate. If correct, check water hardness; hard water (high calcium) can break the corrosion inhibitors. | Operation Type | Concentration (%) | Refractometer

Foam coming out of the spindle. Solution: Check for mechanical leaks pulling air into the pump suction line. Also, verify the water is not too soft (Deionized water causes extreme foaming). Add a defoamer or mix in 10% tap water. Always consult the manufacturer’s Safety Data Sheet (SDS)

Note: Always add concentrate to water, never water to concentrate, to prevent invert emulsion issues. How does it stack up against other common fluids?