Okru Install: Naisenkaari 1997

C:\> copy A:\NAISENKAARI_97.BIN C:\NAISENKAARI\ C:\> cd \NAISENKAARI C:\NAISENKAARI> NAISENKAARI_97.BIN /extract When prompted, select (not "Windows" or "Raw"). Step 5: Configure CONFIG.SYS and AUTOEXEC.BAT Edit C:\CONFIG.SYS using edit and add:

format C: /s Install base DOS to C:\DOS . Once DOS is installed, type: naisenkaari 1997 okru install

If you continue to face errors, check your jumper settings on the Naisenkaari card itself. Pin 7-8 should be jumpered for "Master mode – OKRU kernel." C:\> copy A:\NAISENKAARI_97

@ECHO OFF PROMPT $P$G SET OKRU_DIR=C:\OKRU SET NK_CONFIG=C:\NAISENKAARI\NK97.CFG C:\OKRU\BIN\OKRU.EXE /START C:\NAISENKAARI\NK_INIT.EXE Reboot the system. You should see: Pin 7-8 should be jumpered for "Master mode – OKRU kernel

Remember: patience and period-correct hardware are your greatest allies. The Naisenkaari driver was built for a world without plug-and-play – a world where you, the engineer, controlled every IRQ, every DMA channel, and every line of CONFIG.SYS .

copy A:\OKRU.SYS C:\OKRU\ copy A:\OKRU.EXE C:\OKRU\BIN\ Repeat for Disk 2 and 3, copying all .SYS and .OVL files into C:\OKRU\ . This is the sensitive part. The NAISENKAARI_97.BIN file is a self-extracting archive but not for Windows. Run:

Now edit C:\AUTOEXEC.BAT :